Kippzonen SOLYS 2 Sun Tracker Manuel d'utilisateur télécharger pdf (Page 43)

Install the Shading Ball Rods by sliding them into the designated holes. See figure 4.12 for preliminary

positioning of the Ball Rods in the T-Bar. Fine-tuning of the Ball Rods must be done later in the

installation after the Verification of Levelling Procedure. DO NOT OVER-TIGHTEN the locking screws, it

would make fine-tuning adjustments difficult later in the procedure.

Figure 4.12: Mounting of shading ball rods

Important: It’s important for the detector of the instrument to be fully shaded.

This can be helpful during installation of third party radiometers.

Tip: At this time fine adjust the Shading Ball Rods (of the optional Pointing & Shading Ball Assembly)

such that the Balls cast shadows onto the centres of the sensing elements of the radiometer on

the Top Mounting Plate.

Important:

Check that all unused connectors on the bottom of the SOLYS 2 have their caps installed during

normal operation. The Ethernet connection has a loose gray cap. Both power connections and the

sun sensor have attached caps that should be closed when not in use.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 65 66

Pas de commentaire

Kippzonen SOLYS 2 Sun Tracker Manuel d'utilisateur Page 43