Kippzonen UVS-E-T UV Radiometers Manuel d'utilisateur télécharger pdf (Page 11)

Data logger input channels:

To prevent earth loops that influence the quality of the

data from the radiometer it is recommended to use

floating inputs to measure the output voltage signals. If

the input of the data logger is not floating it may be

useful to test the radiometer signal for noise due to

earth loops over the data logger input channels.

Connection scheme: UV series

Important notes:

- Pin 3 (green wire) is the UV-B or UV-E output.

- For single band UV-B or UV-E instruments, pin 7

(white wire) is not connected.

- The analog ground pin 5 (grey wire) should not be

grounded. This can cause ground loops and

offsets, especially when the 0 Volt of the power

supply is grounded.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 24 25

Pas de commentaire

Kippzonen UVS-E-T UV Radiometers Manuel d'utilisateur Page 11