Kippzonen COMBILOG Data Logger Manuel d'utilisateur télécharger pdf (Page 85)

9 INITIATION AND TEST

9.1 Before Connecting the Device

Before connecting the supply voltage to the data logger

COMBILOG 1022, once again check all connections. Watch

that the supply voltage never exceeds 30 VDC.

9.2 After Connecting the Device

After connecting the supply voltage the data logger displays the

current operating state on the two LEDs at the front of the

device (if the LED-display has not been switched off). The

meanings of the LEDs are given in table 9.1 on the following

page.

If the module was switched off for a longer time, the settings of

date and time should be checked and corrected if necessary

(see chapter 6.2).

9.3 Configuration of the Data Logger

Before entering into operation the data logger has to be pro-

grammed and configured as to its specific application. In most

cases the programming has already been carried out on deliv-

ery (see status of RUN-LED and ERR-LED, table 9.1). The

configuration has to be carried out by the user by means of the

configuration software COMBILOG.EXE on a PC. The installa-

tion procedure is described in APPENDIX E.

Hardware Manual COMBILOG 1022

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 172 173

Pas de commentaire

Kippzonen COMBILOG Data Logger Manuel d'utilisateur Page 85